Transcription
45 TROOP MOVEMENTS
(14) Minimum Requirements for Securing Six Wheel Trucks (Single
or Dual Wheels).—Flat, or Drop End Gondola Cars. See Fig. 10.
Item No. of PCS. Description.
A Brake wheel clearance. See Fig. 6.
B VACANT.
C VACANT.
D 8 6 in, x 8 in. x 24 in. block, (pattern &). Height at point
of contact with tire must be not less than 4 in. from
car floor. Locate in front and rear of front wheels, in
front of outside intermediate wheels and in back of
outside rear wheels. Nail heel of block to car. floor
with three 40-D nails and toe-nail that portion under
tire to car floor with two 40-D nails, before Items "E"
are applied. Not required when Items "F" and "G"
are used.
B 4 2 in. x 4 in. x 36. in. cleats, (pattern 2). Nail lower
for front piece to car floor with three 40-D nails and top piece
wheels. to the one below witfi three 40-D nail»: They may, if of
8 sufficient length, be nailed to top of Items "F", when
for rear used, in which case only one is required at each loca-
wheels. tion.
P 4 6 in. x 8 in. timbers, (pattern 41), lenig^h not less than
overall width of vehicle at car floor, chamfered 2 in.
at point of contact with tires. Apply as shown in
sketch 2 and secure to prevent displacement. Not re
quired when Items "D" are used.
G 16 2 in. x 4 in. x 12 in. cleats, (pattern 1). Locate against
Items "F", lengthwise of car, at center line of tire.
Nail lower piece to car floor with three 40-D nails
and top piece to the one below with three 40-D nails.
Not required when Items "D" are used.
H 64 strands, 2 wrappings, No. 8 Ga. black annealed
wire. Pass through spokes, or holes, in disc wheels
and through stake pockets, tightening only enough
to remove slack. Not required when loaded in gon
dola cars.
Brakes must be applied.
See General Rules for further details.
98
Uncorrected OCR text. Columns and tables may be out of order; the scan is the authority.