Skip to content
WW2 Information

Searchsoon

FM 101-10 Staff Officers Field Manual Organization Technical Logistical Data (1941), p. 145

Page 145 of 363 in FM 101-10

Transcription

64 TROOP MOVEMENTS Block off on the work sheet for each entraining point, by units, the number of trains to load there (for each echelon successively, if the move ment is to be by echelon). Number of trains in the order of their departure from the entraining area. Check to see that each train is allowed time for loading (at least 3 hours between trains from one entraining point if vehicles and materiel are to be loaded. Where only foot elements move by rail and motorized elements of the unit move overland, allow one-half hour for loading and one-half hour for unloading). Check to see that the train density prescribed by the Railway Transpor tation Service is not exceeded and that time is not unnecessarily lost; for instance, with a train density of 36, that one train can leave the entraining area every forty minutes. Make necessary adjustments. Determine the time at which each successive train is to leave the en training area. Determine and enter the time required for trains from each entraining point to reach the forward entraining point (limit of the entraining area). Enter, for each train successively, the time it must leave its entraining point to reach the forward point at the regular intervals of train density (at least, not more than that interval). Prepare one entraining table (Form 11, SOFM 101-5) for each entrain ing point, designating the specific units or elements to be loaded on each train. A detraining table often is not made. When desired, the running time from the entraining point to the detraining point may be added to the time of departure from the entraining point to give the expected day and hour of arrival. 140

Uncorrected OCR text. Columns and tables may be out of order; the scan is the authority.

Original scan

Loading the original scan…
Original scan, PDF page 145. Only this page is downloaded. Open the full PDF

FM 101-10 Staff Officers Field Manual Organization Technical Logistical Data, PDF page 145

100%

Data on this page

5 data points

AttributeValue
Rail entraining at a single entraining point
minimum time between trains (vehicles and materiel loaded)3 hours“(at least 3 hours between trains from one entraining point if vehicles and materiel are to be”
Rail loading time, foot elements only (motor elements move overland)
loading timeone-half“allow one-half hour for loading and one-half hour”
Rail unloading time, foot elements only (motor elements move overland)
unloading timeone-half“allow one-half hour for loading and one-half hour”
Train density example (Railway Transportation Service prescription)
train density36 trains (density figure, unit not stated)“with a train density of 36, that one train can leave the entraining”
Train density example, interval between trains
interval between departuresforty“area every forty minutes.”

Extracted from this page by machine. Each row quotes the text it came from; check it against the scan.