Skip to content
WW2 Information

Searchsoon

FM 101-10 Staff Officers Field Manual Organization Technical Logistical Data (1941), p. 345

Page 345 of 363 in FM 101-10

Transcription

260-261 MISCELLANEOUS DATA • 260. CARRYING CAPACITY OF ICE:b 3 inches ________________Small groups of men 4 to 5 inches _______Horse cavalry in small groups 7 inches _____________Wagons and 75-mm guns 9 to 12 inches ____________Division loads (10 tons) 12 inches —_____________Light tanks (singly) 16 inches ________________Twelve-ton loads 20 inches _______Army loads (approximately 20 tons) 6 New sound ice in floating contact with the water. • 261. CHARACTERISTICS OF METHODS OF EXPRESSING DIRECTIONS OF ANGULAR MEASUREMENTS : Designa tion Azimuth Bearings Compass Clock face, horizontal Clock face, vertical Vertical angle Air and forward observers (FA) Units of angu lar measure ment ttsed Degrees or mils Degrees Points (11° 15' each) Sours on a clock face Sours on a clock face Degrees or mils Per cent or ratio (slopes and roads) Yards R or L Yards O and S Base direction True, magnetic or grid (Y) north un less otherwise stated (south may be used) True or magnetic north and south; whichever is desig nated Magnetic or true north and south 12 o'clock, observer at center Vertical, target or reference point at center Horizontal Line of fire Direction of measurement CJockwise Direction which gives smallest arc (must not exceed 90°) is used and is designated Direction which gives smallest arc From 12 o'clock to the hour indicated From 12 o'clock to the hour indicated Vertically Right or left and short or over and from ob served point Method of expression True (magnet ic) (grid) (Y) azimuth __ mils (__° --') M (S) __<> __' E (W) (N E by E) At __ o'clock At __ o'clock illevation, + ( — ) _ mils <~° --') slope, 10%, gradient 1:10 _._ _R (L) _— 0 (S) NOTE For military purposes, exact directions should normally be expressed as azimuths measured from grid, true, or rarely, magnetic north. 340

Uncorrected OCR text. Columns and tables may be out of order; the scan is the authority.

Original scan

Loading the original scan…
Original scan, PDF page 345. Only this page is downloaded. Open the full PDF

FM 101-10 Staff Officers Field Manual Organization Technical Logistical Data, PDF page 345

100%

Data on this page

7 data points

AttributeValue
ice load capacity
minimum ice thickness for small groups of men3 inches“3 inches ________________Small”
minimum ice thickness for horse cavalry in small groups4-5 inches“4 to 5 inches _______Horse”
minimum ice thickness for wagons and 75-mm guns7 inches“7 inches _____________Wagons”
minimum ice thickness for division loads (10 tons)9-12 inches“9 to 12 inches ____________Division”
minimum ice thickness for light tanks (singly)12 inches“12 inches ____________Division”
minimum ice thickness for twelve-ton loads16 inches“16 inches ________________Twelve-ton”
minimum ice thickness for army loads (approximately 20 tons)20 inches“loads 20 inches _______Army”

Extracted from this page by machine. Each row quotes the text it came from; check it against the scan.