Transcription
45 TROOP MOVEMENTS
motorized units of the United States Armed Forces on open top cars, and
the materials specified under the various figures are minimum requirements.
The loading of units for which no definite figure has been provided,
should conform as nearly as possible to the best example that can be derived
from the figures shown.
In the loading, the hazards connected with high speed, multiple track
railroads, tunnels, electrical conductors and the necessity of protecting
human life and property should be borne in mind, and every effort made
to properly and safely secure all loading before offering it to the railroads
for movement.
a. General Rules.— (1) Selection and Preparation of Car.—Cars must
be inpected to see that they are suitable to carry loads safely to desti
nation. Cars should have good sound floors, and all loose nails or other
projections not an integral part of the car , should be removed. Nails, bolts,
etc., necessary in car construction, when loose, should be made tight rather
than removed.
(2) Brake Wheel Clearance.—See Figure 6. Note minimum clear
ances.
(3) Maximum Load Weights.— In determining the maximum weight
of load, the following shall govern, except where load weight limit has been
reduced by the car owner.
Marked capacity of car Total weight of car and load Load weight
40,000 pounds.___.............. 66,000 pounds........................ 66,000 pounds, less light weight of car
60,000 pounds.....__.............103,000 pounds........................!03,000 pounds, less light weight of car
80,000 pounds._.................136,000 pounds............,...........136,000 pounds, less light weight of car
100,000 pounds__.................169,000 pounds..........,.............169,000 pounds, less light weight of car
140,000 pounds__.................210,000 pounds........................210,000 pounds, less light weitgh of car
200,000 pounds.__.................251,000 pounds........................251,000 pounds, less light weight of car
EXAMPLE
Capacity of car..........................................................,...100,000 pounds
Total weight of car and load.__...............................169,000 pounds
Light weight of car (to be subtracted)...................... 37,000 pounds
Permissible weight of load__.....................................132,000 pounds
Load must be placed on the car so that there will not be more weight on one side of the car than
on the other. One truck of the carrying car must not carry more than one-half of the load weight.
(4) Idler Cars—to be iised as follows:
(a) When load projected beyond end sill of carrying car.
(b) When idler car is used, 4 in. clearance must be mairitained below
overhang portion of load and any part of idler car.
(c) When idler car is used, space on the idler may be utilized for load
ing provided, the ends of such material are located not less than 2 ft. from
ends of overhanging portions.
(5) Clearing Limits.— The height and width of load must be within
the clearance limits of the railroads over which it is to be moved. Army
and Railroad officials must check on clearances prior to each move.
(6) Stakes, Braces, Blocks, Cleats, Wedges.—Such items must be of
hardwood, fir, spruce, or long leaf yellow pine, straight grained and free
from impairing knots.
90
Uncorrected OCR text. Columns and tables may be out of order; the scan is the authority.