Skip to content
WW2 Information

Searchsoon

FM 101-10 Staff Officers Field Manual Organization Technical Logistical Data (1941), p. 97

Page 97 of 363 in FM 101-10

Transcription

4S TROOP MOVEMENTS (11) " Minimum Requirements for Securing Light and Medium Tanks. -Plat, or Drop End Gondola Cars. See Fig. 7. Item A B No. of PCS. 4 4forlight tanks. 6 for medium tanks. D E P G each inside bogie wheel. (Required for light tanks only) Description. Brake wheel clearance. See Fig. 6. 6 in. x 8 in. x 24 in. blocks, (pattern 3), cut to fit con tour of crawler tread. Nail neel of block to car floor with five 40-D nails and toe-nail that portion under crawler tread to car floor with two 40-D nails. Not required when Items "F" and "G" are used. 2 in. x 4 in. x 36 in. cleats, (pattern 2). May be ap plied inside or outside of crawler tread. Medium tanks, oak stays aprox. 3' long should be placed in the cleats on the side of flat cars and the 2x4 placed on edge and nailed down inside of upright. Nail each to car floor with three 40-D nails. VACANT. VACANT. 6 in. x 8 in. timbers, (pattern 4), length not less than overall width of vehicle at car floor, chamfered 2 in. at point of contact with crawler tread. Apply as shown in sketch 3 and secure to prevent displace ment. Not required when Items "B" are used. 2 in. x 4 in. x 12 in. cleats, (pattern 1). Locate against Items "F", lengthwise of car, at center of crawler tread. Nail lower piece to car floor with three 40-D nails and top piece to the one below with three 40-D nails. Not required when Items "B" are used. 4 strands, 2 wrappings, No. 8 Ga. Iblack annealed wire. Secure around axle of each inside bogie wheel and to nearest stake pocket, tightening only enough to remove slack. Not required when loaded in gon dola cars. Brakes must be applied.See General Rules for further details. 92

Uncorrected OCR text. Columns and tables may be out of order; the scan is the authority.

Original scan

Loading the original scan…
Original scan, PDF page 97. Only this page is downloaded. Open the full PDF

FM 101-10 Staff Officers Field Manual Organization Technical Logistical Data, PDF page 97

100%

Data on this page

8 data points

AttributeValue
Light tank securing
pieces required4 pieces“4forlight tanks.”
Tank securing, blocks 6x8x24
40-d nails toe-nailed2 nails“4 strands, 2 wrappings, No. 8 Ga. Iblack annealed”
Tank securing, cleats 2x4x36
40-d nails per cleat3 nails“shown in sketch 3 and secure to prevent displace”
Medium tank oak stays
length3 feet“oak stays aprox. 3' long”
Tank securing, timbers
size6 in. x 8 in.“6 in. x 8 in. timbers”
Tank securing, cleats 2x4x12
40-d nails per piece3 nails“shown in sketch 3 and secure to prevent displace”
Tank securing wire
strands4 strands“4 strands, 2 wrappings, No. 8 Ga.”
wrappings2 wrappings“4 strands, 2 wrappings, No. 8 Ga.”

Extracted from this page by machine. Each row quotes the text it came from; check it against the scan.