Transcription
MILITARY INTELLIGENCE
GERMAN ARMY
[Photograph: three-quarter view of a Mark I tank with a figure standing in the turret hatch]
MARK I TANK, MODEL A
(PZ. KPFW. I (M. G.) (SD. KFZ 101) AUS. A.)
(FORMERLY THE MARK I KRUPP)
- Crew: Two (driver and commander-gunner).
- Armament: Two machine guns coaxially mounted in a turret with telescopic and open sights.
- Ammunition: 70 magazines for machine guns each containing 25 rounds.
- Armor:
- Hull:
- Front .56 inch. Back .4 inch.
- Sides .4 inch. Top .4 inch.
- Turret:
- Front .56 inch. Back .4 inch.
- Sides .4 inch. Top .32 inch.
- Hull:
- Turret: 360° hand traverse. Gunner in suspended seat. Turret floor does not revolve.
- Vision.
- Ventilation.
- Communication: W/T receiver and flags.
- Dimensions:
- Length: 13 feet, 2 inches.
- Width: 6 feet, 9 inches.
- Height: 5 feet, 7 inches.
- Weight:
- Unladen: 5 tons 1 cwt.
- In action: 5 tons 6 cwt.
- Motor:
- Type: Krupp, Model M .305, horizontally opposed, 4-cylinder, 4-stroke.
- Fuel: Petrol.
- Cooling: By air from centrifugal fan, and by a large oil cooler.
- Horsepower: 60.
- Drive: Engine, drive shaft, clutch gear box, bevel drive, steering clutch and brake, reduction drive, and front sprockets.
- Speed: Maximum: 22 mph.
- Cruising radius: 60 to 100 miles.
- Operating distance without refill.
- Gear speeds and ratios: Five forward, one reverse.
- Turning radius.
- Suspension: Five bogie wheels. Front bogie wheel is mounted on a pivot arm. Second and third bogie wheels are an articulated pair mounted on a hull stub axle. The fourth and rear bogie wheels are similarly mounted. The two hull stub axles are connected externally by a girder.
- Performance:
- Ground clearance 12 inches.
- Climbs 27° slope.
- Negotiates 1 foot 4-inch step.
- Crosses trenches 4 feet, 7 inches.
- Fords streams 2 feet.
- Remarks: This model was known previously as the Mk. I Krupp type. They are now considered obsolete. It is used as a training vehicle, perhaps for line of communication protection duties and in modified forms as mobile antitank guns and assault guns. The Mk. I chassis is reported to have been used to provide the mobile chassis for assault guns of 75-, 105-, and 155-mm calibers. Experiments have been made in the western desert, using a flame thrower in the Mk. I tank.
Machine-assisted transcription. Check figures against the scan before relying on them.
