Skip to content
WW2 Information

Searchsoon

FM 101-10 Staff Officers Field Manual Organization Technical Logistical Data (1941), p. 278

Page 278 of 363 in FM 101-10

Transcription

192-193 Chapter 7 FIELD ENGINEERING DATA • 192. PURPOSE.—These data are intended for use as general guides only. Their application should be varied to conform to local field conditions as required in each specific tactical situation, based on the recommendation, after reconnaissance, of the unit engineer charged with the task. • 193. ROADS.—a. Traffic Capacity See par. 48, Chapter 2. 6. Load capacity of civilian roads and bridges.—The design of civilian roads and bridges is based on standard loadings, called H—loadings, in which several vehicles of specified weight follow each other at specified intervals, with, at the same time, loads on the remaining traffic lanes. (Table XXIII, FM 5-35.) This design includes a factor of safety of nearly four to care for variation in strength of materials, variations in construc tion and minor depreciation. In addition, it is standard civilian practice to design for 100% overload where one lane at a time is used and the interval between vehicles is increased. Thus as a guide for military purposes, for infrequent use, civilian roads and bridges may be expected to carry twice the rated load capacity, where restrictions are placed on the number of lanes in use and the speed and intervals between vehicles is controlled. Dur ing hostilities, loads in excess of the above may be carried on the recom mendation of the unit engineer, in accordance with the situation. Plans must in all cases provide for engineer reconnaissance, and, where necessary, reinforcement or repair on roads and bridges under our control, and for engineer troops to accompany advance elements into unreconnoi- tered terrain. c. Construction, maintenance and repair.—Advantage is taken of the available road net, and all means are utilized to repair and maintain exist ing roads to fulfill military requirements, rather than to build new roads. Except for short sections, new road construction is avoided. In the combat zone, no better road should be maintained or built than is essential for the immediate purpose. Minimum width of one-track road is 10 feet; two- track road 18 feet—preferably 20 feet. Drainage is always vital; dry subgrades obtained by ditches, culverts, and smooth graded crowns are most important. On most roads, bridges are sensitive points which may often become bottlenecks to flow of traffic. Alternate crossings or detour routes should be planned for bridges on important roads. The following tables are given for the purpose of rapid, rough esti mates ; more accurate tables should be used for detailed estimates. 273

Uncorrected OCR text. Columns and tables may be out of order; the scan is the authority.

Original scan

Loading the original scan…
Original scan, PDF page 278. Only this page is downloaded. Open the full PDF

FM 101-10 Staff Officers Field Manual Organization Technical Logistical Data, PDF page 278

100%

Data on this page

4 data points

AttributeValue
civilian roads and bridges, overload
load allowance for one lane in use at a time100 percent overload“design for 100% overload where one lane at a time is used”
one-track road
minimum width10 feet“Minimum width of one-track road is 10 feet; two- track road 18 feet—preferably 20 feet.”
two-track road
minimum width18 feet“Minimum width of one-track road is 10 feet; two- track road 18 feet—preferably 20 feet.”
preferred width20 feet“Minimum width of one-track road is 10 feet; two- track road 18 feet—preferably 20 feet.”

Extracted from this page by machine. Each row quotes the text it came from; check it against the scan.