Skip to content
WW2 Information

Searchsoon

German Infantry Weapons (Special Series) (1943), p. 107

Page 107 of 203 in German Infantry Weapons (Special Series)

Transcription

GE'RMAN INFANTRY WEAPONS shoulder stock a quarter turn (in either direction) and then remove. (d) Buffer housing and return spring.-In remov- ing the buffer housing, the large recoil, or return, spring will be released. Therefore, care should be taken to maintain pressure on the buffer housing while removing it. Press the buffer-housing catch, which is located beneath the rear end of the receiver just back of the pistol grip, turn the buffer housing clock- wise 180 degrees (one-half turn), and ease the buffer housing away from the receiver, releasing gradually the tension on the return (recoil) spring. (e) Bolt.-First, press the trigger; then strike the operating handle toward the rear with the palm of the hand, thus bringing the bolt to the rear. Withdraw the bolt from the open rear end of the receiver, if necessary, by pushing with the finger. (f) Barrel.-Proceed as stated in d (4), p. 91, above. (3) Assembly.-Assembly is carried out in the re- verse order of that used in the stripping process. The following steps should be checked when putting the bolt assembly back into the receiver. Insert the bolt head, being sure that the heel of the firing pin (which is on the bolt housing) is on top. The feed-arm op- erating stud should also be upward, and the extractor should be on the bottom side of the bolt. g. Accessories Not all the accessories of the M.G. 42 are known, but they are probably similar to those of the M.G. 34. 94

Uncorrected OCR text. Columns and tables may be out of order; the scan is the authority.

Original scan

Loading the original scan…
Original scan, PDF page 107. Only this page is downloaded. Open the full PDF

German Infantry Weapons (Special Series), PDF page 107

100%

Data on this page

2 data points

AttributeValue
M.G. 42 buffer housing removal
turn180 degrees“180 degrees (one-half turn)”
MG 42 buffer housing
turn to release (stripping)180 degrees“wise 180 degrees (one-half turn)”

Extracted from this page by machine. Each row quotes the text it came from; check it against the scan.