Skip to content
WW2 Information

Searchsoon

German Infantry Weapons (Special Series) (1943), p. 118

Page 118 of 203 in German Infantry Weapons (Special Series)

Transcription

lM~ACHINE GUNS AND MORTARS d. How to Operate (Figs. 55 and 56) (1) Safety.-In the event of a misfire, wait one minute; put on "safe" by pressing in the spring-actu- ated bolt, which is located on the ball-shaped section of the breech (or base) cap, and then turning the bolt in a clockwise direction until the arrow on the bolt Panoramic sight Elevating crank Guide tube Safety bolt Figure 56.-Left view of 8-cm mortar, model 34. points to the letter "S" (sicher--"safe") (about 90 degrees); loosen the mortar barrel clamp, rotate the tube 90 degrees, and tighten the mortar barrel clamp again; and finally gently raise the breech end of the barrel until the shell slides out into an operator's hands. Be sure that the bore of the barrel is kept clean, in order to prevent shells from sticking. 105

Uncorrected OCR text. Columns and tables may be out of order; the scan is the authority.

Original scan

Loading the original scan…
Original scan, PDF page 118. Only this page is downloaded. Open the full PDF

German Infantry Weapons (Special Series), PDF page 118

100%

Data on this page

5 data points

AttributeValue
8-cm heavy mortar 34 misfire
wait before handlingone“wait one minute; put on”
8-cm heavy mortar 34 safety bolt
rotation to safe90 degrees“(about 90 degrees)”
8-cm heavy mortar 34 tube
rotation for barrel clamp change90 degrees“rotate the tube 90 degrees, and tighten”
German 8-cm heavy mortar (s.Gr.W. 34, 81-mm)
wait after misfire before unloadingone“In the event of a misfire, wait one”
tube rotation to unload90 degrees“rotate the tube 90 degrees, and tighten”

Extracted from this page by machine. Each row quotes the text it came from; check it against the scan.