Transcription
GERMANE INFANTRY WEAPONS
between the shoulder of the plunger and the link of
the breech-mlechanism actuating shaft in order to take
the weight off the spring. Remove the axis pin and
the spring case by turning 40 degrees to the right.
Release the extractors, slightly closing the block to
remove the axis pin. Remove the extractors. Open
the breech fully and remove the actuating spindle
and the breech-mechanism lever. Remove the breech-
block.
(b) Recoil.-The recoil cylinder is hydraulic, being
filled from the center of the piston shaft at the rear
by using a screw pump. The liquid is of the glycerine
type. The cylinder contains 2 pints when full. To
disconnect the gun from the recoil system, use a small
flat bar to turn the connecting ring counterclockwise,
about one-half turn. This presses back a safety
plunger at the lower forward face of the breech ring
and locks the firing mechanism.
If, during recoil, the recoil indicator on the right of
the cradle reaches graduation 595, further firing is
unsafe.
German handbooks recommend that no one shall
stand within 35 feet directly in rear of the gun when
it is being fired, as the piece may become separated
from the cradle.
The recuperator is of the double-banked spring
type.
(2) Assembly of breech mechanism.-Insert they
hand-operated block-stop spring and retaining bush.
Place the breechblock in the breech ring in the fully
open position, insert the actuating shaft of the con-
120
Uncorrected OCR text. Columns and tables may be out of order; the scan is the authority.