Skip to content
WW2 Information

Searchsoon

German Infantry Weapons (Special Series) (1943), p. 134

Page 134 of 203 in German Infantry Weapons (Special Series)

Transcription

ANTITANK GUNS AND INFANTRY HOWITZE:RS necting arm into the breech ring, and connect the breech-mechanism lever. Insert the actuating spindle. Insert the extractors by slightly closing the breech to admit the extractor axis pin, and then close the breech. Next, insert the return spring and plunger, placing the flats of the plunger into a link of the breech- mechanism actuating spindle. Insert the axis pin as far as possible. Then release the hand-operated block stop and open the breech until it is held by the extractor claws, and press home the axis pin. Insert the firing pin and release the sear. Replace the main spring and cover plate, giving the cover plate a quarter turn, and release it. E. Carriage (1) Axle.-The axle incorporates an independent suspension, which is, however, locked when firing. The releasing and locking are controlled by the open- ing and closing of the trail legs. (2) Lower carriage.-The lower carriage has a pivot housing and bearing face for the top carriage. It also houses the axle and carries the traversing rack, the traveling clamp, and the locking gear for the trail legs. (3) Traversing mechanism.-The gunner is on the left side of the w;apon and operates the traverse with his right hand by a small handwheel (clockwise to the right, counterclockwise to the left). (See fig. 63.) The traverse is 60 degrees (1,062 mils), and is com- pleted by 301/, turns of the handwheel. 121

Uncorrected OCR text. Columns and tables may be out of order; the scan is the authority.

Original scan

Loading the original scan…
Original scan, PDF page 134. Only this page is downloaded. Open the full PDF

German Infantry Weapons (Special Series), PDF page 134

100%

Data on this page

3 data points

AttributeValue
3.7-cm Pak traverse mechanism
traverse (trails closed per table)60 degrees“The traverse is 60 degrees (1,062 mils)”
3.7-cm Pak traverse handwheel
turns for full traverse30 1/2 (OCR 301/,)“pleted by 301/, turns of the handwheel”
German 3.7-cm Pak
traverse (total)1,062 mils“The traverse is 60 degrees (1,062 mils)”

Extracted from this page by machine. Each row quotes the text it came from; check it against the scan.