Transcription
PISTOLS, RIFLES, AND GRENADES
finger tip to make sure that they are both clear of
cartridges.
e. Ammunition
The ammunition used in this rifle includes various
types of 7.92-mm (.312-inch) small-arms ammunition.
(See pars. 20 to 30, incl., pp. 161-184, below, for an ex-
planation of the labels on ammunition cases.) Ball
ammunition is packed in cases holding 1,500 rounds, and
the label is overprinted i.L. to indicate that the ammuni-
tion in a case is packed in 5-round clips. Do not use am-
munition from cases whose labels are overprinted Ex.,
as this is "dummy," or drill, ammunition.
f. Maintenance
(1) Stripping.-(a) To remove bolt.-Cock the rifle
by working the bolt, and set the safety lever halfway
between the safe and the locked positions. Pull the
bolt back. Then pull out the near end of the bolt stop,
which is located on the left side of the receiver near
the cutoff. Hold the bolt stop out while you remove
the bolt from the receiver.
(b) To disassemble bolt.-The bolt is stripped in the
same manner as that of the U. S. Springfield rifle. Press
in the bolt-sleeve lock and unscrew the bolt sleeve, fir-
ing pin, and spring assembly. Now place the tip
of the firing pin in the hole in the stock of the rifle.
Compress the spring, pushing down on the bolt sleeve
until the bolt sleeve clears the headless cocking piece.
Turn the cocking piece a quarter turn in either di-
rection and remove it from the firing pin shaft. Ease
25
Uncorrected OCR text. Columns and tables may be out of order; the scan is the authority.