Transcription
GE'RMAN INFANTRY WEAP)N'S
up on the bolt sleeve so as not to allow the spring to
escape suddenly. Remove the bolt sleeve and firing-
pin spring from the firing pin.
(c) To remove magazine floor plate.--Insert the
point of a bullet or a pointed tool into the small hole
in the magazine floor plate, and exert pressure while at
the same time pushing the floor plate toward the trig-
ger guard. This will release the catch, and the
magazine floor-plate spring and follower can then be re-
moved and broken down into their separate units.
Further stripping is not usually necessary.
(2) Assembly.-The assembling is done in the re-
verse order to that described in f(1), above.
(3) Care and cleaning.-The care of this rifle is the
same as that required for the U. S. M1903 and M1
service rifles.
g. Accessories
(1) General.-Each rifle is furnished with a short
length of cleaning rod, fitted through the bayonet stud.
The rods from 3 rifles will make one full-length clean-
ing rod. A small metal case carried on the person
holds an oiler, a pull-through, brushes, and short
lengths of tow used as patches. Ammunition is car-
ried in 2 leather ammunition pouches attached to the
belt, which hold 60 rounds in 5-round clips. Additional
rifle ammunition is issued in cloth bandoleers similar
to the U. S. type. Muzzle and breech covers are some-
times used. Rifle grenade launchers may be attached
to the rifle. In addition, a short knife bayonet
26
Uncorrected OCR text. Columns and tables may be out of order; the scan is the authority.