Transcription
GERMAN, INFANTRY WEAPON'S
clockwise, and allow the tension on the return spring
to be gradually relieved.
(e) Bolt.-Strike the operating handle toward the
rear with the palm of the hand, bringing the bolt back.
Withdraw the bolt from the open rear end of the
receiver, pushing with the finger if necessary.
(f) Barrel.-Proceed as stated in d (6), page 73,
above.
(3) Assembly.-Assembly is carried out in the re-
verse order to that used in the stripping procedure.
The following steps should be checked. When putting
the bolt assembly back into the receiver, insert the bolt
head in the receiver so that the bolt rollers fit into the
receiver roller grooves. Make sure that the nail-like
ejector plunger is in its forward position. When as-
sembling the feed block to the feed cover, first center
the belt-feed pawl slide on the feed block. Next, cen-
ter the feed arm extension on the feed cover. Finally,
slide the feed block onto the feed cover so that the belt
pawls will be on the left side of the gun. The raised
rib on the feed arm should match the grooves on the
stud on the top rear end of the bolt carrier.
g. Accessories
Several accessories go with the gun itself. These
are-
(1) Spare barrels, usually three, in a single- and a double-barreled holder;
(2) Tripod for using the weapon as a heavy machine gun (this may have
an antiaircraft mount adapter);
(3) Antiaircraft tripod;
(4) Belts and belt boxes;
(5) Belt drums and belt-drum holders;
82
Uncorrected OCR text. Columns and tables may be out of order; the scan is the authority.