Skip to content
WW2 Information

Searchsoon

German Infantry Weapons (Special Series) (1943), p. 94

Page 94 of 203 in German Infantry Weapons (Special Series)

Transcription

MACHINE GUNS AND MORTARS pushing it forward, and raise the feed cover. Press the feed-cover hinge pin (see fig. 48) from right to left and remove the feed cover. Center the belt feed slide in the feed block and pull the feed block off the feed cover. (c) Shoulder stock.-Press the catch located on the underside of the plastic shoulder stock. Give the Feed-cover hinge pin Folding dust cover Buffer spring Sear Figure 48.-Cross section of trigger, recoil, and feed mechanism of M.G. 34. shoul(ler stock a quarter turn (in either direction) and then remove it. (d) Buffer hotusivg and return spring.-In remov- ing the buffer housing, the large return spring will be released. Therefore, care should be taken to maintain pressure on the buffer housing while removing it. Press the buffer-housing catch, which is located be- neath the rear end of the receiver back of the pistol grip, turn the buffer housing a quarter turn counter- 81

Uncorrected OCR text. Columns and tables may be out of order; the scan is the authority.

Original scan

Loading the original scan…
Original scan, PDF page 94. Only this page is downloaded. Open the full PDF

German Infantry Weapons (Special Series), PDF page 94

100%