Skip to content
WW2 Information

Searchsoon

German Infantry Weapons (Special Series) (1943), p. 85

Page 85 of 203 in German Infantry Weapons (Special Series)

Transcription

GERMAN INFANTRY WEAPONSI Cause 5. Cartridge case is not extracted. The bullet of the new round has struck the cartridge case still sticking in the cham- ber. 6. A cartridge case is not ejected. The cartridge is jammed in the ejector opening by the closing bolt. a. The extractor is worn or broken. b. The extractor spring is weak or broken. c. A cartridge case is jammed in the cham- ber. d. A cartridge case is torn off (ruptured case). a. The ejector is worn. b. The ejector stud is loose or worn. c. The recoil is insuf- ficient. d. A cartridge has bounced outside of the gun and sprung back into the gun through the ejection port. a. Change the bolt. b. Repair spring. the extractor c. Change the belt or drum. Let the bolt spring forward once more, and pull it back again. If this does not help, change the barrel. d. Change the barrel; later remove the car- tridge case from the barrel. a. Change the bolt. b. Insert a new ejector stud. c. See under 2, above, especially a and d. d. Change the position of the gun. (5) To unload.-To unload (using the belt drum or belt), cock the gun by pulling the operating handle to the rear, and set the safety lever to the "safe" position. Raise the feed cover by pushing forward the feed- cover catch (at the rear end of the feed cover). Re- move the belt from the gun. After checking to be sure that the chamber is empty, close the feed cover, 72 Symptom Remedy

Uncorrected OCR text. Columns and tables may be out of order; the scan is the authority.

Original scan

Loading the original scan…
Original scan, PDF page 85. Only this page is downloaded. Open the full PDF

German Infantry Weapons (Special Series), PDF page 85

100%